User Guide

Unpacking & Dimensions
2-2
5975646A BARCOGRAPHICS 8100LC 220496
Unpacking & Dimensions
2-2
5975646A BARCOGRAPHICS 8100LC 220496
Unpacking
To open the banding, pull on the clip as shown in the first drawing.
Pull
To open
Take the projector out of its shipping carton and place it on a table.
For transportation, the projector is mounted on a wooden board with 3 bolts. Use a 13 mm wrench to
remove these bolts.
When using the projector as a table mounted configuration, always mount the 3 supporting feet by
turning in into the provided holes (see drawing on next page).
Warning : To prevent overheating of the projector as table mounted, always remove the wooden board
and turn in the 3 supporting feet to allow air circulation via the built-in dust filter at the bottom.
1 234 5
379
Save the original shipping carton and packing material, they will
come in handy if you ever have to ship your projector. For maximum
protection, repack your projector as it was originally packed at the
factory.
Contents of the shipped box :
- 1 BARCOGRAPHICS 8100LC
- 1 remote control unit RCU + 9V battery
- 1 power cable with outlet plug type CEE7 or ANSI 73.11.
- 1 owner’s manual
- 3 supporting feet
Unpacking
To open the banding, pull on the clip as shown in the first drawing.
Pull
To open
Take the projector out of its shipping carton and place it on a table.
For transportation, the projector is mounted on a wooden board with 3 bolts. Use a 13 mm wrench to
remove these bolts.
When using the projector as a table mounted configuration, always mount the 3 supporting feet by
turning in into the provided holes (see diagram on next page).
Warning : To prevent overheating of the projector as table mounted, always remove the wooden board
and turn in the 3 supporting feet to allow air circulation via the built-in dust filter at the bottom.
1 234 5
379
Save the original shipping carton and packing material, they will
come in handy if you ever have to ship your projector. For maximum
protection, repack your projector as it was originally packed at the
factory.
Contents of the shipped box :
- 1 BARCOGRAPHICS 8100LC
- 1 remote control unit RCU + 9V battery
- 1 power cable with outlet plug type CEE7 or ANSI 73.11.
- 1 owner’s manual
- 3 supporting feet