User Guide

Service Mode
13-10
5975646A BARCOGRAPHICS 8100LC 130696
Service Mode
13-10
5975646A BARCOGRAPHICS 8100LC 130696
Change Projector Address
Every projector requires an individual address between 0 and 255.
This address can be software installed.
To change that address, push the control stick forward or backward
to highlight Change Proj. Address and press ENTER. The Change
Projector Address menu will be displayed and the actual address will
be filled in. The first digit is highlighted. Enter the new projector
address with :
- the digit keys on the RCU or the local keypath or
- use the control stick to the right or to the left to select a digit and
change the value by pushing the control stick forward or backward
until the new value is reached. Continue with the other digits on the
same way.
Select with or
then <ENTER>
<EXIT> to return.
SERVICE
IDENTIFICATION
CHANGE PASSWORD
CHANGE LANGUAGE
CHANGE PROJ. ADDRESS
CHANGE BAUDRATE PC
RESET LAMP RUNTIME
LAMP RUNTINE HISTORY
PANEL ADJUSTMENTS
I2C DIAGNOSIS
CHANGE PROJ. ADDRESS
Enter new address
001
Select with or
Reprogram with or
or numeric keys
<ENTER> to confirm
<EXIT> to return
Change Baudrate PC
The communication speed between projector and computer, e.g. PC
or MAC, has 8 possible speeds. The baud rate speed can be software
set up.
Highlight Change Baud rate PC by pushing the control stick forward or
backward and press
ENTER to display the Change Baudrate PC.
Select with or
then <ENTER>
<EXIT> to return.
SERVICE
IDENTIFICATION
CHANGE PASSWORD
CHANGE LANGUAGE
CHANGE PROJ. ADDRESS
CHANGE BAUDRATE PC
RESET LAMP RUNTIME
LAMP RUNTINE HISTORY
PANEL ADJUSTMENTS
I2C DIAGNOSIS
Change Projector Address
Every projector requires an individual address between 0 and 255.
This address can be software installed.
To change that address, push the control stick forward or backward
to highlight Change Proj. Address and press ENTER. The Change
Projector Address menu will be displayed and the actual address will
be filled in. The first digit is highlighted. Enter the new projector
address with :
- the digit keys on the RCU or the local keypath or
- use the control stick to the right or to the left to select a digit and
change the value by pushing the control stick forward or backward
until the new value is reached. Continue with the other digits on the
same way.
Select with or
then <ENTER>
<EXIT> to return.
SERVICE
IDENTIFICATION
CHANGE PASSWORD
CHANGE LANGUAGE
CHANGE PROJ. ADDRESS
CHANGE BAUDRATE PC
RESET LAMP RUNTIME
LAMP RUNTINE HISTORY
MORE...
CHANGE PROJ. ADDRESS
Enter new address
001
Select with or
Reprogram with or
or numeric keys
<ENTER> to confirm
<EXIT> to return
Change Baudrate PC
The communication speed between projector and computer, e.g. PC
or MAC, has 8 possible speeds. The baud rate speed can be software
set up.
Highlight Change Baud rate PC by pushing the control stick forward or
backward and press
ENTER to display the Change Baudrate PC.
Select with or
then <ENTER>
<EXIT> to return.
SERVICE
IDENTIFICATION
CHANGE PASSWORD
CHANGE LANGUAGE
CHANGE PROJ. ADDRESS
CHANGE BAUDRATE PC
RESET LAMP RUNTIME
LAMP RUNTINE HISTORY
MORE...