User Guide

Service Mode
5975646A BARCOGRAPHICS 8100LC 130696
13-7
Service Mode
5975646A BARCOGRAPHICS 8100LC 130696
13-7
R
B
V
R
B
V
100 - 230 V
9 - 4 A
60 - 50 Hz
RS232 OU T
0 I
This de vice co mplie s w it h Par t 1 5 of the FC C ru le s. O per a tio n
is subject to following two conditions :
(1) This device may not cause harmful interference
(2) This device must accept any interference received
including interference that may cause undesired operation
IR-ACKNOWLEDGED
IR-RECEIVED
DIAG NOST ICS
CODE
IR-RECEIVER
R
B
V
R
B
V
100 - 230 V
9 - 4 A
60 - 50 H z
RS232 OU T
0I
This de vice co mplie s w it h Par t 1 5 of the FC C ru le s. O per a tio n
is subject to following two conditions :
(1) This device may not cause harmful interference
(2) This device must accept any interference received
including interference that may cause undesired operation
IR-ACKNOWLEDGED
IR-RECEIVED
DIAG NOST ICS
CODE
IR-RECEIVER
Loosen the locking
screws.
Open the top cover
Change Password
This item is password protected when the password strap is installed.
How to enable or disable the password function ?
The password function is enabled when the password strap on the
controller module is installed.
To get acces to the controller module, handle as follows :
- Power down the projector and disconnect the power cord from the
wall outlet.
- Turn both lock screws of the front top cover with a screwdriver or coin
counter clockwise.
- Lift up and pivot the top cover. Attention : the cover is not secured
with an incorporated support. When opening, turn it over slowly and
lay it down on the second part of the top cover.
R
B
V
R
B
V
100 - 230 V
9 - 4 A
60 - 50 Hz
RS232 OU T
0 I
This de vice co mplie s w it h Par t 1 5 of the FC C ru le s. O per a tio n
is subject to following two conditions :
(1) This device may not cause harmful interference
(2) This device must accept any interference received
including interference that may cause undesired operation
IR-ACKNOWLEDGED
IR-RECEIVED
DIAG NOST ICS
CODE
IR-RECEIVER
R
B
V
R
B
V
100 - 230 V
9 - 4 A
60 - 50 H z
RS232 OU T
0I
This de vice co mplie s w it h Par t 1 5 of the FC C ru le s. O per a tio n
is subject to following two conditions :
(1) This device may not cause harmful interference
(2) This device must accept any interference received
including interference that may cause undesired operation
IR-ACKNOWLEDGED
IR-RECEIVED
DIAG NOST ICS
CODE
IR-RECEIVER
Loosen the locking
screws.
Open the top cover
Change Password
This item is password protected when the password strap is installed.
How to enable or disable the password function ?
The password function is enabled when the password strap on the
controller module is installed.
To get acces to the controller module, handle as follows :
- Power down the projector and disconnect the power cord from the
wall outlet.
- Turn both lock screws of the front top cover with a screwdriver or coin
counter clockwise.
- Lift up and pivot the top cover. Attention : the cover is not secured
with an incorporated support. When opening, turn it over slowly and
lay it down on the second part of the top cover.