Specifications

Driver and Software Installation
58
The master Install program will make two passes through the
driver installation process (i.e. License Agreement, Verify
Installation Options, etc.).
6. During installation, there may be a fair amount of display
flashing, and the install wizard window may appear on different
displays. This is an expected behavior.
7. When the installation of all components has completed, the
automatic reboot window will be displayed. Allow the system to
reboot.
To verify that the driver was installed, go to the Windows Control
Panel, select System, select Device Manager, then select Display
Adapters. Verify that Barco MXRT graphics boards were properly
identified, as shown below:
Automated display configuration
Once the drivers, software and documentation have been installed
and your system has been rebooted, the Barco Monitor Plug and Play
Software should automatically detect your Barco displays and attach
them to the desktop with the correct resolution. If the Barco Monitor
Plug and Play Software fails to detect your Barco displays or fails to
attach them to the desktop correctly, please set the resolution of your
Barco Display(s) following the instructions in the Configuring
Windows section of this manual.