User Guide

R5900024 /08 ClickShare CS-100 25

The Base Unit can be inside a cabinet in the meeting room, or put on the meeting room table or mounted on a

wall. Check the Installation Guide for instructions on how to install the Base Unit.

Image 2-2

1 USB Type-A port

2 Status LED ring

3 Standby Button

4 Kensington lock

USB Port

The USB port is used to update the software of both the Base Unit and the Buttons.

When plugging in the Button into the Base Unit, the Button is paired to the Base Unit. The Base Unit checks

whether the software and firmware of the Button is up to date. If not, the Base Unit updates the software and/

or firmware.

Use a convertor to connect a Button with an USB Type-C

connector to the Base Unit.

Status LED ring

The color of the LED ring around the power button of the Base Unit gives information on the status of the

system.

LEDs behavior Explanation

static red • receiving content from the Buttons and streaming towards the

display.

• pairing and software update of the Button is done. You can now

unplug the Button from the Base Unit.

• during the first phase of the Base Unit boot process.

blinking white • system is starting up (during the second phase)

• Button pairing is in progress

• software update of the Base Unit

breathing white • ECO standby mode

static white • awake and ready (i.e. showing the welcome message on the

display)

• pairing is done

red blinking • an error occurred

dark • deep standby/off

Introduction to CS-100