User Manual

5. Preparing the buttons
5. PREPAR IN G THE BUTTONS
Overview
• Pairing
• Pre-install of the Launc her service
• ClickShare launcher installer
5.1 Pairing
Pairing of the Buttons with the Base Unit
To be able to use a Button it s hould be assigned to the Base Unit yo u are using. This process is c alled pairing. By default, the
Button(s) delivered with the C S E-200 set are alrea dy paired to the specificBaseUnit.
In case you buy additional B uttons or when a Button should be assigned to another Base Unit, the Button needs to be paired (again).
The Button software update runs in the background and will not impact users while using the system. If desired, this feature can
be disabled in the Web Interface. When downgrading or u pdating to an older version of the Base Unit software the Buttons need to
paired m anually to update their software and that only in ca se the Button update over Wi-Fi is disabled.
A Bu tton can only be paired to one Base Unit at a time.
The Button will always make co nnection to the Base Unit it was last pair
ed to.
To pair a Button to the Base unit
1. Insert the Button in the US B port at the front of the Base Unit you are using.
Image 5-1
R5900023 CLICKSHARE CSE-200 24/05/2017 21