User guide

3. Display installation
WARNING: N ever move a display attached to an arm by pulling or pushing the display
itself. Instead, make sure that the arm is equipped with a VESA approved handle and
use this to move t he display.
Please refer to the instruction manual of the arm for more information and instructions.
3.9 F irst time starting up
Overview
You are now ready to start up your Coronis Fusion 6MP for the first time.
1. Switch on your Coronis Fusion 6MP as described in "Stand-by switching", page 16.
2. Turn on the computer connected to your display.
If you have properly installed your display and display controller, the Windows start-up messages will
appear once the boot procedure is finished.
Your Coronis Fus ion 6MP display will be running in a basic video mode at a default re-
fresh rate when first time starting up. If you are using a Barco displ ay controller, please
consult the dedicated use r guide available on the s ystem CD to install the drivers, s oft-
ware and documentation. When this is done, your display will automatically detect the
connected video input signal(s) and apply the correct video mode and refresh rate.
14 K5902055 CORONIS FUSION 6MP 14/11/2014