Specifications

Installing drivers and software
58
attach them to the desktop correctly please refer to the section, Setting
the resolution of your B
ARCO CORONIS Display, on page 67 in the
Troubleshooting section of this manual.
Reinstalling drivers
You can install new drivers or reinstall existing drivers at any time by
using the Barco Set-up wizard on your B
ARCO CORONIS Display System
Installation CD-ROM, see Installing the B
ARCOMED CORONIS drivers and
software, on page 55 of this manual.
Uninstalling the drivers and software
To uninstall the Barco drivers, software or documentation for your Barco
Coronis Display Systems, please use the Windows Add/Remove
Programs utility. This can be found in the Windows Control Panel.
Note:
If you installed your BARCOMED CORONIS drivers with DualView
enabled, the wizard will warn you that DualView must be disabled
before the drivers can be uninstalled. This is normal, please follow
the prompts from the wizard.
Command line (Silent) Install of Drivers and Software
Specifying the silent install option causes most of the GUI associated
with the installer to disappear. A background progress window will still
be visible, but no user input will be required.
The silent install behavior is dictated by the SETUP.INI file. Each
application is allowed to have separate command-line parameters for
normal and silent installs.
To install the drivers and software silently, please follow the steps
below:
1. Insert the B
ARCO CORONIS Display System Installation CD-ROM into
your CD/DVD drive. When the Barco Product Installation Wizard
starts click “Cancel”.
2. Click the Start button in the task bar.