Specifications

Installing your Barco display controller

11. Reconnect any cables you have disconnected and plug in the

computer’s power cord.

12. Turn on the display(s) and then your computer.

Turning on your system

If you have properly installed your graphics card, the Windows

start-up messages will appear once the boot procedure is finished.

13. Install the drivers, QAWeb software and documentation for your

ARCO CORONIS Display System by following the instructions in the

section “Installing drivers and software” on page 50 of this

manual.

WARNING - Turn on your display(s) before you turn on

your computer. Failure to do so could damage your dis-

play(s).

Your Barco display(s) will be running in a basic video

mode at a default refresh rate. Higher resolutions and

refresh rates, such as 1536x2048@60Hz, are not avail-

able at this stage of the installation. Once you have

installed the B

ARCO CORONIS Display System drivers and

software, the Barco monitor Plug and Play software

should automatically set the resolution for the displays

of your B

ARCO CORONIS Display.