Specifications

Installing your Barco display controller
26
Installing your Barco display controller
This chapter will guide you through the physical installation of the
display controller(s) for your B
ARCO CORONIS Display System.
Overview
Prior to installing the display controller(s) for your BARCO CORONIS Display
System in your PC please take a few minutes to familiarize yourself with
both the display controller(s) and the PCIe slots in your computer.
Types of display controllers for Coronis Display Systems
There are four different models of display controllers available for your
B
ARCO CORONIS Display System.
If you are using the B
ARCOMED CORONIS PCIe display controller, you will
need to decide if you are going to use its on-board VGA capabilities. If
you are, check the setting of the Jumper at J-1 on the display controller
(see figure 7). By default, VGA should be enabled, on the top two pins.
To disable the on-board VGA capabilities of you B
ARCOMED CORONIS PCIe
display controller move the jumper so that it is on the middle and
bottom pins.
CAUTION – Wear a grounded, protective ESD strap when
handling or during installation of the display controller.
Electrostatic charges can damage the display controller.
Board Model VGA Jumper Recommended PCIe Slot
B
ARCO CORONIS MXRT 2100 No x16
B
ARCO CORONIS MXRT 5100 No x16
B
ARCO CORONIS MXRT 7100 No x16
B
ARCOMED CORONIS PCIe Yes x8