User manual

Barco DPMS Screen Saver

6. Select the screen saver you wish to use during the work day in the

“Screen Saver During Work Day” section.

7. Select the amount of time you wish to spend in the Stand-By and

Suspend states after the work day has ended. Please note that

after the time specified has elapsed when you are in Stand-By or

Suspend, you will automatically go into the Off state.

8. Select the amount of time it takes for your display to warm up. If

you have a Barco Medical Display, select “Barco Quick Start”. If

you are using a non-Barco display, select the amount of time it

takes your display to warm up via the “Monitor Setting” section.

Contact your display vendor for this warm-up time. On Barco

CORONIS displays, the I-GUARD will stabilize the image within a

few seconds after the display returns to the active state, thus

eliminating the need for a warm-up period at the beginning of the

work day.

9. If you wish to use this DPMS screen saver as the screen saver at

logon time, check the “Use As Logon Screen Saver” box in the

“Additional Options” section.

10. Save your preferences by pressing the “Save As” button and

entering a new profile name in the “Save Profile Setting” dialog

box.

11. Apply your new scheme by clicking “OK”.

12. Click “OK” again to close the “Display Properties Control Panel”.

Installing or Reinstalling BARCO DPMS

To install or reinstall the BARCO DPMS Screen Saver insert the CORONIS

Software CD in the appropriate device on your computer and run the

BarcoMed Product Install Wizard (please see the section Software

Installation for complete instructions).

Special Note: Reinstalling the BARCO DPMS Screen Saver will over write

the DPMS configuration settings and you will need to reconfigure the

DPMS settings on your system.