User manual

Barco DPMS Screen Saver
76
Stand-By or Suspend states. If the user wishes to go into the Stand-By or
Suspend states before going into the Off state, select the required
amount of time for each state.
If requested, the display will first go into Stand-By state, then into
Suspend state, and then into Off state. The properties of DPMS states are
listed in the following table:
Monitor Settings
Select the amount of time the display requires to warm-up. Since all CRT
based displays require some warm-up time before they are at full
performance, this ensures that the display is ready for use at the
beginning of the work day.
If you have a Barco Medical Display, select “Barco Quick Start.” If a non-
Barco display is being used, select the amount of time it takes your
display to warm up via the “Monitor Setting” section. Contact your
display vendor for this warm-up time.
On Barco CORONIS displays, the I-GUARD will stabilize the image within
a few seconds after the display returns to the active state so there is no
need for a warm-up time period.
Table 1:
DPMS State Power Savings
Monitor Recovery
Time
On None N/A
Stand-by Minimal Short
Suspend Substantial Longer
Off Maximum Longest