User manual

Software Installation
60
15. Click “Next” on the Welcome Screen of the Coronis 5MP Mammo
I-Switch Software InstallShield Wizard to continue the installation.
Click “Cancel” to cancel the Coronis 5MP Mammo I-Switch
Software installation and return to the BarcoMed Product Install
Wizard.
16. The Coronis 5MP Mammo I-Switch Software must be installed on a
local hard drive in order for it to function correctly. We recommend
that you install it in the default location: C:\WINNT. If you wish to
install the Coronis 5MP Mammo I-Switch Software in a different
location use the “browse” button on the Install Location Screen of
the Coronis 5MP Mammo I-Switch Software InstallShield Wizard.
Click “Next” to continue the installation.
17. Click “Next” on the “Setup has enough information” screen to
continue.
18. When the Coronis 5MP Mammo I-Switch Software InstallShield
Wizard has finished installing the software, it will tell you that it
has finished installing the software on your computer and prompt
you to click “Finish” to complete the setup. Click “Finish” to exit
the Coronis 5MP Mammo I-Switch Software InstallShield Wizard
and to return to the BarcoMed Product Installation Wizard.
19. Click “Finish” to exit the BarcoMed Product Installation Wizard or
click “Back” if you wish to install additional BarcoMed software.
Windows may now warn you that you must restart your computer
before the new settings will take effect.
Click “Yes” to restart your computer now.
Click “No” if you wish to restart your computer later.
When your system restarts, boot normally and log in using an account
with administrator privileges and set the resolution of your Coronis 5MP
Mammo displays.
Barco monitor plug and play software
After your system restarts and you have logged in, Windows will install
the Barco Monitor Plug-n-Play software. If Windows displays the screens