User manual

Software Installation
58
If the Wizard failed to successfully install the selected driver, it will
warn you that the installation failed. Click “Finish” to return to the
BarcoMed Product Install Wizard. The wizard will now begin
installing the next selected piece of BarcoMed Software. Click
“Cancel”, then click “Yes” then click “Finish”. Now “Back” and
try reinstalling the driver following the steps above or using the
steps outlined in “Reinstalling or Updating your BarcoMed Drivers”
section found later in this chapter.
BARCO DPMS Screen Saver Installation
Click “Next” on the Welcome Screen of the BARCO DPMS InstallShield
Wizard to begin the installation. Click “Cancel” to cancel the DPMS
installation and return to the BarcoMed Product Install Wizard (see
figure 26 on page 58).
Figure 26
11. The “Customer Information” screen will appear. The Installer will
automatically fill in the blanks using the information entered
when Windows was installed on your system. You may change this
information if you wish. Click “Next” to continue.
12. The “Setup Type” page will now appear. Choose “Typical” to
install the default schemes with English names. Choose “Custom”
to install the default schemes with either Dutch or German names.