User manual

Software Installation
55
Figure 22
Click “OK” to install the new driver. If you don’t want to replace
the exiting driver, click “OK” and then click “Cancel”.
7. Your selection on the “Enable DualView” screen determines if
DualView is enabled or not. If you wish to enable DualView
“check” the checkbox next to “Enable the DualView device?”, and
click “Next”.
If you do not wish to enable DualView leave the checkbox empty
and click “Next” to continue.
8. The “Device Confirmation” screen displays the device driver that
will be installed. If you want to change your selection, click
“Back” to return to the Device Selection Screen. Click “Next” to
begin installing the driver. Click “Cancel” to abort the driver
installation.
Caution: Once you click “Next”, you cannot cancel the driver
installation.
Prior to beginning the installation the BarcoMed Driver Install
Wizard will warn you that while the driver is being installed your
display may flicker. Click “OK” to continue.
9. When the screen shown in figure 23 on page 56 or figure 24 on
page 56 appears, click “Yes” or “Continue Anyway” to continue.
This screen may appear multiple times.