User manual

Software Installation
53
If it determines that the Microsoft Installer is either out of date or
missing, it will display the screen shown in figure 20 below. Click
“OK” to continue, the wizard will then install a newer version of
the Microsoft Installer.
Figure 20
The BarcoMed Product Installation Wizard will advise you when it
has successfully installed the new version of the Microsoft Installer.
Click “OK”.
The Wizard may prompt you to restart your system. If it does, click
“Yes” to restart your system now.
When your system restarts log in using an account with
administrator privileges. Windows will again launch the “Found
New Hardware Wizard” for each BarcoMed 5MP2FH it finds in your
system. Click “Cancel”. Continue to click “Cancel” until Windows
stops launching the “Found New Hardware Wizard - Video
Controller”. Again, please be patient as Windows will again scan
its library of Plug-and-Play device drivers to see if it has a driver
for your BarcoMed 5MP2FH controller.
The BarcoMed Product Installation Wizard’s welcome screen will
now be displayed (see figure 21 on page 54). By default all the
software on the BarcoMed Software CD will be selected. For the
initial installation we recommend that you install all of the
software. If you do not want to install a particular BarcoMed
Software product at this time, deselect it by clearing the checkbox
next to it.
5. Click “Install” to continue or “Cancel” to exit the wizard.