User manual

Software Installation

Tip: These instructions apply to both Windows 2000 and

Windows XP.

Preparation

Prior to installing your Coronis 5MP Mammo software the following

should be done.

1. Install the BarcoMed 5MP2FH display controller in your system.

2. Connect the Coronis 5MP Mammo display panel(s) to the

BarcoMed 5MP2FH display controller and power supply.

3. Decide if you want to install the Barco DPMS Screen Saver and the

Coronis I-Switch Software in addition to the driver.

4. Decide if you are going to install the BarcoMed 5MP2FH driver with

DualView enabled or disabled.

5. Decide what palette mode you want to use.

6. Decide if you want to enable the DirectDraw capabilities of the

BarcoMed 5MP2FH display controller.

Caution: Both displays connected to a single display controller

must have the same physical orientation and resolution in order to

be attached to the Windows desktop. This is a requirement of the

Windows operating system.

Using the BarcoMed Product Installation Wizard

To install your Coronis 5MP Mammo Windows Display Controller Driver,

Barco DPMS Screen Saver and the Coronis I-Switch Software for the first

time follow the steps below.

If you are reinstalling the drivers or installing a new driver release over

an existing driver release skip to the step 5:

1. Boot your system, and log in using an account with administrator

privileges.