User manual

Installing the BarcoMed 5MP2FH display controller
39
Jumper location
There is one user settable jumper on the BarcoMed 5MP2F. It is used to enable
or disable the VGA capabilites of the display controller.
Figure 4: VGA Jumper Enlarged View
Using the VGAcapabilities of the BarcoMed 5MP2FH
Prior to installing the BarcoMed 5MP2F, decide if you are going to use its
on-board VGA capabilities. If you are, check the setting of the Jumper at
J-1 on the graphics board. (See VGA Jumper, J-1, Figures 3 and 4) By
default, VGA should be enabled, on the top two pins.
NOTE: To use multiple 5MP2F display controllers in a single host
with VGA enabled, you need to enable VGA on only ONE of the
5MP2F display controllers and disable VGA on ALL other BarcoMed
display controllers.
Examples of PCI slots
Although the BarcoMed 5MP2FH has a 64 bit PCI connector, it functions
as a 32 bit board. It may be installed in either a 32 bit or 64 bit slot
with no loss of functionality. Figure 5 illustrates the types of slots so that
you can correctly identify which one to use for the BarcoMed 5MP2FH.