User manual

Driver Re-installation, updates or removal
131
4. Please turn to Step 6 on page 54 in the section titled “Driver
Installation” and follow the instructions to finish reinstalling or
updating your BarcoMed 5MP2FH driver.
When the driver has finished installing, click “Finish”. Then click
“Finish” again.
Reboot the system when prompted and then reset the resolution of
your displays if necessary.
Uninstalling the BarcoMed 5MP2FH driver
To remove the BarcoMed 5MP2FH display controller driver from
your system you must be logged in using an account with
administrator privileges.
Uninstalling the BarcoMed 5MP2FH driver
1. Insert your BarcoMed 5MP2FH Software CD into your computer’s
CD drive. If the “BarcoMed Product Installation Wizard” doesn’t
start within one minute, browse the contents of your Coronis 5MP
Mammo Software CD and double click on the file: “Setup.exe” to
start the wizard.
2. The BarcoMed Product Installation Wizard will display its welcome
screen.
3. Make certain that the checkbox next to the driver is checked and
that all other checkboxes are unchecked (see figure 51 on
page 132). Click “Install” to continue.