Specifications

System manual Coronis 1MP 71
BarcoMed software driver installation
The BarcoMed Product Installation Wizard will begin by inspecting
your system to make certain that all of the Windows components
it needs are up to date. If they are, the BarcoMed Product
Installation Wizard will display the BarcoMed Product Installation
Wizard’s welcome screen (figure 10 below).
Figure 10
If it determines that the Microsoft Installer is either out of date or
missing, it will display the screen shown in figure 11 below. Click
“OK” to continue, the wizard will then install a newer version of
the Microsoft Installer.
Figure 11
The BarcoMed Product Installation Wizard will advise you when it
has successfully installed the new version of the Microsoft
Installer. Click “OK”.
The Wizard may prompt you to restart your system. If it does, click
“Yes” to restart your system now.
When your system restarts log in using an account with
administrator privileges. Windows will again launch the “Found
New Hardware Wizard” for each BarcoMed display controller it