Specifications

System manual Coronis 1MP 68
BarcoMed software driver installation
for less than the maximum number of displays supported by your
configuration. (See table on following page for examples.)
snoituloseRdetroppuSfoelbaT
/emaNyalpsiD
forebmuN
sdaeH
tiartroP epacsdnaL
HF2PM3
daeHelgniS
daeHlauD
daeHirT
daeHdauQ
zH95@8402x6351
zH95@8402x2703
zH95@8402x8064
zH95@8402x4416
ZH06@6351x8402
ZH06@6351x6904
ZH06@6351x4416
ZH06@6351x2918
HF2PM2
daeHelgniS
daeHlauD
daeHirT
daeHdauQ
ZH06@0061x0021
ZH06@0061x0042
ZH06@0061x0063
ZH06@0061x0084
zH06@0021x0061
zH06@0021x0023
zH06@0021x0084
zH06@0021x0046
HF2PM1
daeHelgniS
daeHlauD
daeHirT
daeHdauQ
zH06@0821x4201
zH06@0821x8402
zH06@0821x2703
zH06@0821x6904
zH06@4201x0821
zH06@4201x0652
zH06@4201x0483
zH06@4201x0215
Select “OK”.
4. Select the “Test” button and click on “OK” to test the display. You
will be asked if it displayed correctly. If the test pattern displays
correctly, select “Yes”. If not, click on the“List all Modes” button
and try selecting another mode.
5. In order to apply your changes, you need to click on the “OK”
button in the “Display Properties” dialogue box, however this
button will not be visible because you are running in VGA mode.
Select “OK” by pressing “CTRL” + “Enter”.
6. Windows may be asked if you want to restart your computer, if it
does select “Yes” to restart your computer. Even if Windows does
not ask you if you want to restart your computer, you must restart it
and boot normally for your changes to take effect.
7. When you system restarts select the “NT Version 4.0” option
( NOT the VGA Mode option ). Log in as usual.
If you wish to change the number of CORONIS display panels you
are using, this can be done using the “BarcoMed Driver Tab” of the
Windows Display Control Panel.