Specifications

System manual Coronis 1MP 28
INSTALLATION
Precautions
• Keep your original packaging. It is designed for this display and is
the ideal protection during transport.
• Avoid reflections in the flat panel to reduce eye strain.
• Place the display on a strong and stable table or desk.
• Keep the display away from heat sources and provide enough
ventilation in case it is built in a rack or console.
• Make sure all equipment is switched off before connecting the
cables.
Before installing the display
Important:
In the factory, the height-positioning system in the display foot is
locked in place with a strap to prevent damage during transportation.
Before installing the display, you must remove this strap.
Strap
To remove the strap:
1 Position the display with its rear side facing you.
2 If the foot cover is mounted on the foot, lift up the 2 clips of the foot
cover to release the cover from the foot.
3 Pull the lower side of the cover towards you and simultaneously
slide the cover downward.
4 Pull the red strap out of its holes in the foot.
We suggest leaving the foot cover off until after you have connected
the signal cables to the display.
Display installation