User`s manual
Table Of Contents
- Preliminary Remarks
- Abbreviated summary
- Design and functions
- Operation
- Controlling
- Menu structure
- Maintenance and servicing
- Technical data
- OverView mDG50-DL
- Overview mDR50-DL
- OverView mDR+50-DL
- OverView cDG67-DL
- OverView cDR67-DL
- OverView cDR+67-DL
- OverView cDG80-DL
- OverView cDR+80-DL
- Electrical data illumination unit 120 W
- Optical data illumination unit 120 W, projection unit XGA resolution
- Optical data illumination unit 120 W, projection unit SXGA resolution
- Optical data illumination unit 120 W, projection unit SXGA+ resolution
- Electrical data illumination unit 100 W
- Optical data illumination unit 100 W, projection unit XGA resolution
- Optical data illumination unit 100 W, projection unit SXGA resolution
- Optical data illumination unit 100 W, projection unit SXGA+ resolution
- Optical data illumination unit 200 W, projection unit XGA resolution
- Use of 3200K filter cartridge
- Operating conditions
- Interfaces
- Scope of delivery
- Consumables
- Spare parts
- Controller
- Addresses
- Trouble shooting
- Configuring notes
7. Maintenance and servicing
Barco - OverView D series - Doc-3353-2 - user's manual - Revision 05 - Aug 2005
________________________________________________________________________
7-17
7.3.6 Replacing the filter pad
The filter pad must be replaced regularly. The operating period of a filter pad depends on the quality of the sup-
plied air.
• Switch the projector in Standby mode.
• Switch off power by pressing OFF.
Switch off the equipment before replacing the filter pad in order to avoid severe
contamination of OverView D
• Lift the cover of the filter pad slightly and remove it.
Figure 7-16
Removing the cover and the filter pad
• Remove the filter pad.
• Insert the new filter pad as indicated on its frame.
• Insert the cover of the filter pad and press it slightly down.
• Switch on power by pressing ON
Never push against a used air filter pad! The trapped dust particles will be released!