User`s manual

7. Maintenance and servicing
Barco - OverView D series - Doc-3353-2 - user's manual - Revision 05 - Aug 2005
________________________________________________________________________
7-13
Figure 7-7
lamp and lamp housing
• Mind the position of the fingers: the force is to apply on the outer part of the module
Figure 7-8
applying the force on the lamp module
• Press the lamp module tightly into its socket
• Apply the securing ring on the lamp and press it while turning
• Turn the securing ring until its hooks click round the guide rods.
Figure 7-9
inserting the securing ring
• Close the lamp door
• Use the hexagon key and lock the lamp door by turning the screw a quarter turn clockwise.
The lamp door must not be open for more than 15 minutes. If not closed within this
period, the projector will show a warning, and then go to standby after another 5
minutes.
If the operation mode of the projector has been Hot Standby, the new lamp is immediately switched on.