User`s manual
Table Of Contents
- Preliminary Remarks
- Abbreviated summary
- Design and functions
- Operation
- Controlling
- Menu structure
- Maintenance and servicing
- Technical data
- OverView mDG50-DL
- Overview mDR50-DL
- OverView mDR+50-DL
- OverView cDG67-DL
- OverView cDR67-DL
- OverView cDR+67-DL
- OverView cDG80-DL
- OverView cDR+80-DL
- Electrical data illumination unit 120 W
- Optical data illumination unit 120 W, projection unit XGA resolution
- Optical data illumination unit 120 W, projection unit SXGA resolution
- Optical data illumination unit 120 W, projection unit SXGA+ resolution
- Electrical data illumination unit 100 W
- Optical data illumination unit 100 W, projection unit XGA resolution
- Optical data illumination unit 100 W, projection unit SXGA resolution
- Optical data illumination unit 100 W, projection unit SXGA+ resolution
- Optical data illumination unit 200 W, projection unit XGA resolution
- Use of 3200K filter cartridge
- Operating conditions
- Interfaces
- Scope of delivery
- Consumables
- Spare parts
- Controller
- Addresses
- Trouble shooting
- Configuring notes
6. Menu structure
Barco - OverView D series - Doc-3353-2 - user's manual - Revision 05 - Aug 2005
________________________________________________________________________
6-20
6.6.3 Over temp protection
Figure 6-28
Status menu: Over Temp Protection
To view or to switch on/off the Over Temp protection, proceed as follows:
• Use the cursor key to highlight Over temp Protection.
• Press Enter to select.
The currently selected status is indicated by white dot.
Use the cursor key to highlight the desired status.
Press Enter to select.
This command refers to the internal temperature sensor. Per default, Over Temp Protection is enabled. In case a
critical temperature is reached, the projector is shut down within five minutes to prevent the system from severe
damage. An Error Message is displayed.
If desired, the customer can disable this behavior. However he should be aware that the device can be damaged!
It is highly recommended NOT to switch of Over Temp Protection.