User`s manual

6. Menu structure
Barco - OverView D series - Doc-3353-2 - user's manual - Revision 05 - Aug 2005
__________________________________________________________________________
6-6
6.4.6 Source selection
This menu is only available for projections units with firmware 3.x, XGA and SXGA+
resolution!
Projection units with Firmware 3.x feature two DVI-D inputs, thus two sources can simultaneously be connected.
The selection of the source to be displayed is done in the Source Selection menu. The following operating
modes are available Manual, Auto Preference, Auto Switch.
• Use the cursor keys to highlight Source Selection
• Press ENTER to select.
• The currently selected status is indicated with a white dot.
• Use the cursor keys to highlight the desired operating mode
• Press Enter to select.
Figure 6-7
Operation menu,Source Selection
Manual
Selecting this command displays a dialog where the source to be displayed can be selected:
Figure 6-8
Operation menu,Source Selection, Manual
Select the desired Source (Source 1 or Source 2). This source will be displayed. In case this source fails, the
background as selected in Operation | Background (color bar, blue, black) will be displayed, no matter if there is
a signal applied to Source 2 or not. The status of Source 2 has no impact on the behavior.
In this operating mode, the behavior is the same as with one DVI-D input only, except that there is the possibility
to connect two sources and select alternatively one them without the need of re-cabling.