User`s manual

5. Controlling
Barco - OverView D series - Doc-3353-2 - user's manual - Revision 05 - Aug 2005
__________________________________________________________________________
5-3
5.2 Terminology of the RCU controls
1 Function keys have no function for this projector
2 ADJ ADJUST key, to enter or exit the adjustment mode.
3 Address key (recessed key), to enter the address of the projector (between 0 and 9). Press the
recessed address key with a pencil, followed by pressing one digit button be-
tween 0 and 9.
4 Selection key has no function for this projector
5 PAUSE has no function for this projector
6 Standby stand by button, to start projector when the power switch is switched on and to
switch off the projector without switching off the power switch.
7
Mute has no function for this projector
8 Help has no function for this projector
9 Digit buttons To enter the remote control address
10 Audio controls have no function for this projector
11 Picture controls Except for brightness and contrast, these keys have no function for this projector
12 PHASE has no function for this projector
13 Freeze has no function for this projector
14 TEXT has no function for this projector
15 ENTER to start up the adjustment mode or to confirm an adjustment or selection in the
adjustment mode.
16 Cursor Keys to make menu selections when in the adjustment mode.
RCU
cursor key up
cursor key down
cursor key right
cursor key left
Use the cursor keys up or right for increasing a value.
Use the cursor keys down or left for decreasing a value.
17 EXIT to leave the adjustment mode or to scroll upwards when in the adjustment mode.
18 RC operating
indication
lights up when a button on the remote control is pressed. (This is a visual indicator
to check the operation of the remote control)