User`s manual
Table Of Contents
- Preliminary Remarks
- Abbreviated summary
- Design and functions
- Operation
- Controlling
- Menu structure
- Maintenance and servicing
- Technical data
- OverView mDG50-DL
- Overview mDR50-DL
- OverView mDR+50-DL
- OverView cDG67-DL
- OverView cDR67-DL
- OverView cDR+67-DL
- OverView cDG80-DL
- OverView cDR+80-DL
- Electrical data illumination unit 120 W
- Optical data illumination unit 120 W, projection unit XGA resolution
- Optical data illumination unit 120 W, projection unit SXGA resolution
- Optical data illumination unit 120 W, projection unit SXGA+ resolution
- Electrical data illumination unit 100 W
- Optical data illumination unit 100 W, projection unit XGA resolution
- Optical data illumination unit 100 W, projection unit SXGA resolution
- Optical data illumination unit 100 W, projection unit SXGA+ resolution
- Optical data illumination unit 200 W, projection unit XGA resolution
- Use of 3200K filter cartridge
- Operating conditions
- Interfaces
- Scope of delivery
- Consumables
- Spare parts
- Controller
- Addresses
- Trouble shooting
- Configuring notes
10. Configuring notes
Barco - OverView D series - Doc-3353-2 - user's manual - Revision 05 - Aug 2005
________________________________________________________________________
10-3
Maintenance area
The floor space for OverView D is calculated from the basic area of the structure. A maintenance area must be
provided behind each OverView D over the complete width. This area must be permanently accessible. The exact
regulations for such a maintenance area can be obtained from the specifications for working premises. The fol-
lowing picture refers to OverView cDG67-DL.
Figure 10-1
Linear and polygonal set-up of OverView cDG67-DL
(All dimensions measured in millimeters!)
With regards to maintenance area, please note that there may be laws concerning safety stan-
dards in your country!
The O
VERVIEW D Display Wall can have a linear or curved arrangement. Standard curved configurations are avail-
able with with angles of 3, 5, and 8 degrees for OverView cD, or 5 and 8 degrees for 50" systems..
Other angles on request!