User`s manual

doc-3331-2 OverView cDG67-DL (August 2003) 7-12
7.3.4 Disposi ng Lamp Modules
Note that there may be laws concerning disposal and recycling of burnt-out lamps
in your country! Please contact your local authorities to get further information!
7.3.5 Insertin g a Lamp Module
The following description applies if the lamp has already been removed as described above and
the lamp cover is still opened.
 Fetch the lamp module on its housing. The power socket is on the right side.
 Insert the lamp carefully. Take care that the "tubes" slide on the guide rods [2].
Figure 7-7
lamp and lamp housing
 Mind the position of the fingers: the force is to apply on the outer part of the module
Figure 7-8
applying the force on the lamp module
 Press the lamp module tightly into its socket
 Apply the securing ring on the lamp and press it while turning
 Turn the securing ring until its hooks click round the guide rods.