User`s manual

doc-3331-2 OverView cDG67-DL (August 2003) 7-9
7.3.2 Unpack ing a Lamp Module
The packaging product uses a strong, highly-resilient low-slip film to surround the lamp module,
protecting it from shock and vibration.
The lamp module is packed between two layers of highly resilient low-slip film. The resilient sus-
pension film is tough and retains its effectiveness for return shipments and multiple uses.
To ensure that the lamp module is held securely in place the upper layer is pressed against the
lamp module and will pop up when the adhesive tape of the package is removed. Do not jump!
To ensure that the lamp module is held securely in place the upper layer is pressed
against the lamp module and will pop up when the adhesive tape of the package is
removed. Do not jump!
Caution: Don't touch the glass top of the reflector!
Place the cardboard box upright according to the instruction printed
on the box.
Remove the adhesive tape. Be aware that the upper layer will pop
up!
Open the box and remove the upper layer.
Take hold of the lamp and lift it out.
Take care that you don't touch the glass top of the reflector!
Now you can insert the lamp as described in the following chapter
If you accidentally made any fingerprints on the glass top of the reflector, clean the
glass top with alcohol before inserting the lamp module!
After the lamp is removed, put the upper layer back in the box. Save
the entire package in case the lamp has to be shipped again.
To ship the lamp module, use the original package and re-pack the lamp module
between the two layers of highly resilient low-slip film.
To pack the lamp module, proceed in the reversed order, please! Don't touch the
glass top of the reflector! Take hold on the fitting and place the lamp module upside
down onto the lower layer. Press the upper layer firmly against it, "opening" on top
side, and close the box with adhesive tape!