User`s manual

doc-3331-2 OverView cDG67-DL (August 2003) 6-14
6.6.3 Automa tic Startup
OverView DG
Operation
Identification
Over Temp Protection
4
4
Standby timer..
Automatic startup
4
Lamps BrightnessStatus
On
Off
Figure 6-22
Status menu, Automatic startup
To view or switch on/off the Automatic startup, proceed as follows:
 Use the cursor key to highlight
Automatic startup.
 Press
Enter to select.
The currently selected status is indicated by white dot.
 Use the cursor key to highlight the desired status.
 Press
Enter to select.
If
Automatic startup is ON, the projector will immediately be started after being connected to the
mains (power switch switched on).
If
Automatic startup is OFF, the projector will go in Standby mode after being connected to the
mains (power switch switched on).
6.6.4 Standby Timer
OverView DG
Operation
Identification
Over Temp Protection
Automatic startup
4
4
4
Standby timer..
Lamps Brightness
Installation
Status
Figure 6-23
Status menu, Standby timer
If there is no signal, and the standby timer is enabled, a dialog box is displayed and the projector
will shut down after a determined time (power save).
Message
No signal available.
The projector will go to Standby in 300 sec.
Figure 6-24
dialog box warning about the projector switching to standby