User`s manual

doc-3331-2 OverView cDG67-DL (August 2003) 6-13
If Long is selected, a list of parameter is shown. This list shows important information for the
Barco service technician.
Parameter
17511
22512
3599813
4014
5015
616
717
818
919
10 20
Figure 6-20
projector identification long: dialog box showing service information
6.6.2 Over Te mp Protection
OverView DG
Operation
Identification
Automatic startup
4
4
Standby timer..
Over Temp Protection
4
Lamps BrightnessStatus
Disabled
Enabled
Figure 6-21
Status menu: Over Temp Protection
To view or to switch on/off the Over Temp protection, proceed as follows:
 Use the cursor key to highlight
Over temp Protection.
 Press
Enter to select.
The currently selected status is indicated by white dot.
 Use the cursor key to highlight the desired status.
 Press
Enter to select.
This command refers to the internal temperature sensor. Per default,
Over Temp Protection is en-
abled. In case a critical temperature is reached, the projector is shut down within five minutes to
prevent the system from severe damage. An Error Message is displayed.
If desired, the customer can disable this behavior. However he should be aware that the device can
be damaged!
It is highly recommended NOT to switch of Over Temp Protection.