User`s manual

doc-3331-2 OverView cDG67-DL (August 2003) 6-11
6.5.6 Reset ru ntime
Status
OverView DG
Operation
Active Lamp
History...
Lamp Optimization...
4
Mode 4
Runtimes...
Reset runtime
4
Lamps
Brightness
Figure 6-16
Reset runtime
After replacement of the lamp, the serial number of the new lamp has to be entered.
The command
Reset runtime displays the dialog to enter the serial number.
To enter the serial number of the new lamp, proceed as follows:
 Use the cursor key to highlight
Reset runtime.
 Press
Enter to select.
The following dialog is displayed:
Reset lamp runtime
Enter serial number of new lamp
Lamp 1
Accept
Cancel
000000
Figure 6-17
dialog to enter the serial number of a new lamp
 Use the cursor keys to highlight the input field.
 Use the numeric keys on the RCU to enter the serial number of the new lamp.
 Click
Accept to activate the serial number.