Operator`s manual

BlendPRO Quick Start Guide
1. Equipment Setup
Connect the image sources, BlendPRO and projection devices as required for the application. A typical 4 screen
system is shown above. Turn the equipment on. Connect a laptop with the BlendWizard application installed to the
Controller Console Port. For detailed instructions on how to install the BlendWizard to your laptop please refer to
Chapter 2; BlendWizard Installation instructions.
2. System Configuration and Adjustments
The BlendWizard will walk you through the series of steps required to configure and adjust the system. The steps are
outlined below for reference, however, much of the process is automated by BlendWizard. For detailed explanations
please refer to Chapter 2; Detailed instructions for configuring a wide screen Presentation.