Operator`s manual

66 BlendPRO – Wide Screen Image Processor Manual # 26-0206000-00 / Revision A
screens.
type - Color Adjust type; [A|B|C], All|Brightness only|Contrast only. If type is not defined, type
will be set to All.
Example: RGBADJ (RGB color adjustment on output 1-4, for both Brightness and Contrast.)
Command:
RPBDAC threshold
Description: Rear Panel DAC threshold.
Parameters: threshold - threshold in volts [0 – 4.99]
Query:
RPBDAC?
Returns the current rear panel DAC threshold.
=threshold
Example: RPDAC 2 (Rear panel DAC threshold set to 2 volts.)
RPDAC? (Returns rear panel DAC threshold.)
Command:
RPBINSEL select
Description: Rear Panel input selection. Selects either BNC or HD-15 connectors for inputs.
Parameters: select - input select [0|1] BNC|HD15
Query:
RPBINSEL?
Returns the current rear panel input selection.
=select
Example: RPINSEL 1 (Active rear panel input type is HD-15.)
RPINSEL? (Returns rear panel input type.)
Command:
SMODEBP mode
Description: Serial Mode. Selects between RS-232 or RS-485 serial modes.
Parameters: mode - Mode; [0|1], RS-232|RS-485
Query:
SMODEBP?
Returns the current serial mode.
=mode
Example: SMODEBP 1 (Sets Serial mode for RS-232.)
SMODEBP? (Returns serial mode.)
Command:
SYSAVE
Description: Saves the system parameters to non-volatile RAM. The system parameters
stored are the output format, sync, and frame rate, data doubling and edge feather parameters and
serial port configuration parameters. Upon power up, the system parameters stored in non-volatile
RAM are used for system configuration.
Parameters: None
Example: SYSAVE (System parameters are saved to non-volatile RAM.)
Command:
TDIBP nn
Description: Front Panel Display Intensity.
Parameters: nn - intensity; [0-15]
Query:
TDIBP?
Returns the current front panel display intensity.
=nn
Example: TDIBP 7 (Sets front panel intensity to 7.)
TDIBP? (Returns front panel intensity.)