Operator`s manual

Manual # 26-0206000-00 / Revision A BlendPRO – Wide Screen Image Processor 61
Description: Print BlendPRO Checksums
Parameters: None
Example: CSUM (Displays BlendPRO file checksums for factory use.)
Command:
DDBL mode
Description: Enable/Disable Data Doubling. Sets data doubling mode for the system, recalculates
register values and updates.
Parameters: mode - Enable/Disable; mode[0|1], Off|On
Query:
DDBL?
Returns the data doubling mode for the system
=mode
Example: DDBL 1 (Enables Data Doubling)
DDBL? (Returns Data Doubling mode.)
Command:
DISP just width
Description: Display Setup. Sets up output display justification and overlap width for the system,
recalculates blending and data doubling registers to reflect new settings.
Parameters: just - Justification; [0|1], Left|Center
width - Overlap Width; [64 – HActive/# of Projectors-1]
Query:
DISP?
Returns the Display Setup information.
=just width
Example: DISP 0 64 (Set justification to left and overlap width to 64.)
DISP? (Returns display setup justification and width.)
Command:
ECHOBP n
Description: Sets the serial port echo mode for rs-232 protocol mode.
Parameters: n - Mode; [0|1], Disable|Enable
Query:
ECHOBP?
Returns the current serial echo state.
=n
Example: ECHOBP 0 (Disables echo of serial port.)
ECHOBP? (Returns echo state of serial port.)
Command:
EFTA o s en w exp
Description: Edge Feather Advanced Mode. Sets the mode and gamma exponent for the selected side.
Parameters: o - Output Screen; [1-4]
s - Side; [L|R], Left|Right
en - Mode; [0|1], Disable|Enable
exp - Gamma; [1.0-5.0]
Query:
EFTA? o s
Returns the Edge Feather Advanced Mode LUT values for the selected output screen and side.
=en exp
Example: EFTA 4 R 1 1.5 (Enables feathering on the right side with a gamma of 1.5 on output 4.)
EFT? 2 L (Returns edge blending mode, and gamma settings for the left side of output 2.)
Command:
EFTB en exp
Description: Edge Feather Basic Mode. Sets the mode, and gamma exponent.