Operator`s manual

60 BlendPRO – Wide Screen Image Processor Manual # 26-0206000-00 / Revision A
BlendPRO
TM
Command List/Description
Command:
AUTOPOS in
Description: Automatic Input Position Adjust. The HBars test pattern with Raster Box enabled must be coming
into the input channels being used prior to using this command.
Parameters: in - Input Screen; [1-4]. If in not defined, auto position adjustment done on all input channels.
Example: AUTOPOS (Adjust position on input 1-4 automatically.)
Command:
BLKGN out gain
Description: Black Level Offset Adjustment. Sets black level offset adjustment register for the selected output
screen.
Parameters: out - Output Screen; [1-4]
gain - Gain/Offset value; [0-255]
Query:
BLKGN? out
Returns the black level offset for the output screen.
=gain
Example: BLKGN 1 25 (Set black level offset on output screen 1 to be 25.)
BLKGN? 3 (Returns black level offset of output screen 3.)
Command:
BPCTRL mode
Description: BlendPRO Control Mode. Sets BlendPRO Control Mode to Basic / Advanced.
Parameters: mode - Basic/Advanced; mode; [0|1]Basic|Advanced
Query:
BPCTRL?
Returns the BlendPRO Control Mode.
=mode
Example: BPCTRL 1 (Set BlendPRO Control Mode to Advanced.)
BPCTRL? (Returns BlendPro Control Mode.)
Command:
BRDGSEAM mode
Description: Bridge Seam Removal Mode.
Parameters: mode - Mode; [0|1], Disable|Enable
Query:
BRDGSEAM?
Returns the bridge seam removal parameter.
Example: BRDGSEAM 1 (Enables seam removal.)
BRDGSEAM? (Returns bridge seam removal mode.)
Command:
BRTHRS threshold
Description: Bridge Seam Flat Field Threshold.
Parameters: threshold - Threshold; [8-255]
Query:
BRTHRS?
Returns the bridge seam flat field parameter.
Example: BRTHRS 16 (Set bridge seam flat field threshold to 16.)
BRTHRS? (Returns bridge seam flat field threshold.)
Command:
CSUM