Operator`s manual

Manual # 26-0206000-00 / Revision A BlendPRO – Wide Screen Image Processor 55
RS-485 Config Menu
ID
The RS-485 ID number can be set from 1 to 32. The BlendPRO RS-485 ID in a multi-screen configuration must be
set to follow the ScreenPRO IDs. In a four-screen configuration (see figure 2-2) the BlendPRO ID must be set to 5. In
a five-screen Configuration (see figure 2-3) the first BlendPRO ID must be set to 6 and the second BlendPRO ID
must be set to 7. In a six-screen configuration (see figure 2-4) the first BlendPRO ID must be set to 7 and the second
BlendPRO ID must be set to 8.
Baud Rate
The following baud rate settings are supported 1200, 2400, 9600, 19.2K, and 38.4K.
Data Bits
The number of data bits per character can be set to 7 or 8.
Stop Bits
The number of stop bits can be set to 1 or 2.
Parity
Parity can be set to Even, Odd or None.
Reset RS-485
All RS-485 parameters can be reset to factory defaults by selecting this menu item and pressing the SEL key.
VFD Brightness
The VFD Brightness menu selections controls the intensity of the front panel vacuum fluorescent display (VFD). The
adjustment range is 0 to 15. 0 is the dimmest setting and 15 is the brightest. We recommend using a low intensity
setting to avoid “burn-in” of the display. The factory default setting is 8.
Tech Support Menu
RS-485 CONFIG
ID 1
BAUD RATE 38.4K
DATA BIT 8
STOP BIT 1
PARITY NONE
RESET RS-485