Operator`s manual

52 BlendPRO – Wide Screen Image Processor Manual # 26-0206000-00 / Revision A
System Options Menu
The System Options Menu allows the user to control input and output sync selection, VFD brightness, change the
configuration of the serial port, provides information for access to factory technical support and allows the system to
be completely reset to factory default values.
Input Source
The Input Source menu item allows the user to select the rear panel input select to be used. The input source can be
either BNC or HD-15.
Input Sync Menu
This menu is used to select the input sync type for each input video. This menu can be accessed from the SYSTEM
SETUP->SYSTEM OPTIONS menu. Configuration parameters entered in this menu are saved in non-volatile
memory for each input source using the SYSTEM SAVE menu. If the SAVE menu item is not selected, the
information will not be restored upon the next system power up sequence.
Input Channel Select
The input channel’s sync format to be adjusted is selected with this menu item. Selection options are 1 to 4 for a
BlendPro controlling the first four screens. For a BlendPro controlling screens 5 and above, the value can be 5 to 8.
Input Sync Select
The Input Sync Select menu item allows the user to select one of three different modes (H/V, COMP or SOG). H/V
(separate horizontal and vertical sync) is the default setting. The other selection modes are Comp (separate
SYSTEM OPTIONS MENU
INPUT SOURCE BNC
INPUT SYNC >>
OUTPUT SYNC >>
SERIAL MODE RS-232
CONFIG SERIAL >>
VFD BRIGHTNESS 8
TECH SUPPORT >>
FACTORY RESET
INPUT SYNC
INPUT SELECT 1
SYNC SELECT H/V