Instruction manual

ScreenPRO-II Controller • User’s Guide 97
4. Menu Orientation
Input Menu
lîÉêë~ãéäÉ=páòáåÖ=jÉåì
The figure below illustrates the Oversample Sizing Menu. All functions apply to the
selected source.
Figure 4-7. Oversample Sizing Menu (sample)
With Oversample enabled, the following timing parameters allow you to adjust the image
to properly fit the layer’s blinking raster box.
• ID — indicates the ID of the associated ScreenPRO-II.
~ If “All” is shown in a widescreen configuration, menu values represent
those of the lowest numbered ID in the destination. When a parameter is
adjusted, all values for all ScreenPRO-II’s in the destination will snap to
the new value.
~ If an individual ID is shown (e.g., 2), it represents that ScreenPRO-II
alone, and adjustments will only affect that unit.
• Layer — for widescreen destinations, indicates the layer on which you are
adjusting the selected input.
• Select and adjust Right Edge, Left Edge, Top Edge or Bottom Edge as
required, to fit the image precisely in the layer’s blinking raster box.
• Press {SAVE} to save the selected input in the designated input file.
Top Edge
Bottom Edge
Left Edge
296
35
B
A
C
K
N
A
V
A
D
J
OVERSAMPLE SIZING SRC_1
ID ALL
803
S
A
V
E
FORCE
ACQUIRE
Layer [ A ]
Right Edge 1320
Note
The ID line only appears when a widescreen destination is
selected.
Important
In a widescreen configuration, because the electronics on
individual ScreenPRO-II scalers may not match from unit to
unit, you may be required to adjust ScreenPRO-II scalers and
layers individually — by first selecting a specific destination
ID, followed by a specific layer.