Instruction manual

ScreenPRO-II Controller • User’s Guide 95
4. Menu Orientation
Input Menu
páòáåÖ=jÉåì
From the Input Menu, press {SIZING} to display one of two “context sensitive” Sizing
Menus
— they change depending on the selected Sampling Mode.
• If 1:1 Sampling is selected, the 1:1 Sizing Menu appears.
• If Oversample is selected, the Oversample Sizing Menu appears.
Each menu and function is described below.
NWN=páòáåÖ=jÉåì
The figure below illustrates the 1:1 Sizing Menu. All functions apply to the selected
source.
Figure 4-6. 1:1 Sizing Menu (sample)
With 1:1 Sampling enabled, the following timing parameters allow you to adjust the image
to properly fit the layer’s blinking raster box.
• ID — indicates the ID of the associated ScreenPRO-II.
~ If “All” is shown in a widescreen configuration, menu values represent
those of the lowest numbered ID in the destination. When a parameter is
adjusted, all values for all ScreenPRO-II’s in the destination will snap to
the new value.
~ If an individual ID is shown (e.g., 2), it represents that ScreenPRO-II
alone, and adjustments will only affect that unit.
H Active
H Position
V Total
H Total
V Active
V Position
[ 858 ]
720
[ 0 ]
486
36
B
A
C
K
N
A
V
A
D
J
1:1 SIZING SRC_1
ID ALL
123
S
A
V
E
FORCE
ACQUIRE
Clock Phase 0
Layer [ A ]
Note
The ID line only appears when a widescreen destination is
selected.