Instruction manual

ScreenPRO-II Controller • User’s Guide 57
3. Hardware Installation
Connection Charts
• Digital Router I/O Chart
If you are using external routing, complete the digital I/O router chart for your
digital input and output connections. The chart can also be used to specify router
outputs that connect to Aux destinations.
• Analog Input Chart — Direct or DA Connections
If you are using internal routing, complete the analog input chart for direct or DA
analog connections to each ScreenPRO-II and other target analog destinations.
Be sure to check (
3) whether or not the analog input is a direct connection, or
from a DA output.
• Digital Input Chart — Direct or DA Connections
If you are using internal routing, complete the digital input chart for direct or DA
digital connections to each ScreenPRO-II and other target analog destinations.
Be sure to check (
3) whether or not the digital input is a direct connection, or from
a DA output.
• DVI Connection Chart
For all system configurations, complete the DVI Connection Chart to map your
Background and DSK DVI connections. Be sure to check (3) whether or not the
DVI source originates from a multi-head graphics card, or a DA (or splitter).
• Standard Destination Chart
For all system configurations, complete the Standard Destination Chart. The
ScreenPRO-II Controller enables you to configure up to four standard
destinations. Note that the chart is also used to map the usage of BlendPRO-II in
widescreen configurations.
• Auxiliary Destination Chart
For all system configurations, complete the Auxiliary Destination Chart. The
ScreenPRO-II Controller enables you to configure up to four auxiliary
destinations.
Before you complete the actual charts, please review the sample charts as provided in the
following two sections:
• “Sample Connection Charts — External Routing”, page 58.
• “Sample Connection Charts — Internal Routing”, page 62.