Instruction manual

ScreenPRO-II Controller • User’s Guide 47
2. Hardware Orientation
Front Panel Sections
Move Setup — two functions are provided:
• Press Move Setup to set up a “move” for a PIP or Key, enabling you to choose
the move’s start and end points.
• Double-punch the Move Setup button to un-define (or clear) the “move setup” for
the selected layer.
In Chapter 6, refer to the “
Using Move” section on page 238 for complete instructions.
Move — press to pend a “move” for a PIP or Key, enabling you to fly the PIP or Key from
one location to another on the next auto transition.
In Chapter 6, refer to the “
Using Move” section on page 238 for complete instructions.
Mix Source — in “Mix Mode” (with the Split button off) press Mix Source to co-locate both
PIPs in the mixer. Layers
A and B will be exactly the same size — in exactly the same
position.
Mix Source and Swap modes are mutually exclusive. In Chapter 6, refer to the
“
Understanding Split and Mix Modes” section on page 228 for instructions.
Swap — in “Mix Mode” (with the Split button off) press Swap to allow both PIPs in the
mixer to be located independently. Layers
A and B can be positioned and sized anywhere
as desired.
Mix Source and Swap modes are mutually exclusive. In Chapter 6, refer to
the “
Understanding Split and Mix Modes” section on page 228 for instructions.
Toggle — press to toggle sources back and forth with each transition. Once a source
transitions off Program within a PIP, it “flip-flops” to Preview.
Toggle is used with both the
Mix Source
and Swap modes, and also functions with background transitions. In
Chapter 6, refer to the “
Understanding Split and Mix Modes” section on page 228 for
details.
Freeze — enables you to freeze a layer on both Program and Preview.
In Chapter 6, refer to the “
Using Freeze” section on page 236 for instructions.
Move
Setup
Move
Mix
Source
Swap
Toggle
Freeze