Instruction manual

ScreenPRO-II Controller • User’s Guide 45
2. Hardware Orientation
Front Panel Sections
• When the Red LED above a source button is blinking:
~ The mixer is set to Mix Mode (the Split button is not lit).
~ The blinking Red LED indicates the layer that is on Program.
~ The alternate layer is enabled for modification on Preview, and its
associated raster box blinks.
S The Red LED above source 1 is blinking, and the Red LED above Layer A is
blinking. This indicates that the mixer is set to
Mix Mode, source 1 is on
program in
Layer A, and Layer B is active for modification on Preview.
• Multiple Red LEDs can be lit simultaneously, but only one Red LED can be
blinking — indicating a “
Mix Mode” association between a source and a layer.
• Source buttons cannot be selected if they have not been assigned during the
source setup procedure. The button will not light.
• Source buttons are also used to route inputs to selected Aux destinations. In
Chapter 6, refer to the “
Working with Destinations” section on page 222 for
details.
Shift — the Shift button is a toggle: press once to light, press again to turn off. When lit,
press the desired source button to access the
second row of numbered sources (9 - 16).
Note
When the Controller is locked, source buttons are used to
enter the 4-digit password. In Chapter 6, refer to the
“
Locking and Unlocking the Controller” section on
page 252 for details.
Shift