Instruction manual

42 ScreenPRO-II Controller • User’s Guide
2. Hardware Orientation
Front Panel Sections
All — the All button works in conjunction with the currently selected bus (as chosen with
the
DEST/AUX button):
• Press All once to turn all “defined” destinations on.
• Double-punch the All button to turn all “defined” destinations off.
In Chapter 6, refer to the “
Working with Destinations” section on page 222 for complete
instructions on all destination modes.
gçóëíáÅâ=pÉÅíáçå
The figure below illustrates the Joystick Section.
Figure 2-5. Joystick Section
When a PIP or Key is selected in the Layer Control Section, the controls in the Joystick
section are automatically assigned to manipulate that feature on
Preview. When none of
the six function buttons are lit, the 3-axis Joystick has the following functions:
• X-Axis Control — Move the Joystick left and right to move the PIP (or Key) left
and right respectively.
• Y-Axis Control — Move the Joystick up and down to move the PIP (or Key) up
and down on Preview.
• Z-Axis Control — Twist the Joystick’s top knob clockwise and counterclockwise
to increase or decrease the PIP (or Key) size.
All
Note
The All button is also used (in conjunction with the Page
button) to lock and unlock the Controller. In Chapter 6, refer
to the “
Locking and Unlocking the Controller” section on
page 252 for details.
Source Crop
Top
Left
Bottom
Right
Reset
Fine
Adjust
Adjustment Panel
Note
The Z-Axis Control can also be used to increase or
decrease the value of a highlighted parameter, such as a
matte color, key clip and gain, border size and much more.