Instruction manual
ScreenPRO-II Controller • User’s Guide 33
2. Hardware Orientation
ScreenPRO-II Controller Rear Panel
4) Ext Comm Port
One 9-pin D Ext Comm connector is provided for RS-232 communications with a
serial device, such as a router. The port is configured as follows:
~ DCE, 115K baud, 8 data bits, 1 stop bit, no parity bits
In Appendix A, refer to the “
Serial Connector” section on page 261 for pinouts.
5) Console Port
One 9-pin D connector is provided for RS-232 “command line” communications
with the ScreenPRO-II Controller, and for downloading code in the field. The port
is configured as follows:
~ DCE, 115K baud, 8 data bits, 1 stop bit, no parity bits
The serial port can be connected to a standard PC serial port with a straight
through DB-9 to DB-9 cable. In Appendix A, refer to the “
Serial Connector”
section on page 261 for pinout details.
6) Ethernet Port
One RJ-45 connector is provided for 10/100BaseT Ethernet communications with
the ScreenPRO-II Controller. When (optionally) connecting the Controller to
peripheral devices (such as BlendPRO-II), a standard Ethernet hub or switch on
an isolated network is recommended.
The Ethernet port is 10/100 Mbit auto sensing capable, and is configured to run as
a DHCP server. A variety of Barco Folsom protocols for communication, control,
and code loading are implemented. The Ethernet connector is compatible with:
~ Standard RJ-45 Ethernet cables
~ Neutrik EtherCon
®
series cables
In Appendix A, see the “
Ethernet Connector” section on page 260 for pinouts.
7) Adjustable Feet
The two rear feet of the ScreenPRO-II Controller are adjustable, enabling you to
raise the rear of the Controller for increased Touch Screen visibility.
Figure 2-2. Controller Side View, showing adjustable feet retracted and extended
8) AC Connector and Fuse
One AC Connector with integral Fuse is provided to connect the ScreenPRO-II
Controller to your facility’s AC power source. Please note:
~ The integral switch turns the chassis on and off.
~ The fuse rating is T250V, 2A. For continued protection against risk of
fire, replace only with a fuse of the same type and rating.