Instruction manual

252 ScreenPRO-II Controller • User’s Guide
6. Operations
Locking and Unlocking the Controller
içÅâáåÖ=~åÇ=råäçÅâáåÖ=íÜÉ=`çåíêçääÉê
This section provides instructions for locking and unlocking the Controller.
S Prerequisite:
~ Ensure that you are familiar with the Lockout Code Menu and its
associated submenu. In Chapter 4, refer to the “
Lockout Code Menu”
section on page 136.
 Use the following steps to lock the Controller:
1. On the Lockout Code Menu, select the type of lockout code you wish to use —
once the panel is unlocked:
Default or Custom.
2. If Custom is selected, use the Change Lockout Code Menu to enter the desired
code. Make a note of the selected code.
3. To lock the Controller, press and hold the PAGE button (in the Presets Section),
then press the
ALL button (in the Destination/Aux Bus). The message
"
KEYBOARD LOCKED" appears on the menu.
 Use the following steps to unlock the Controller:
1. Press and hold the PAGE button, then press the ALL button. The Enter Lockout
Code
menu appears.
2. Use the eight numbered buttons on the Source Selection Bus to enter the code.
~ If the correct code has been entered, the message "Unlocking
Controller
" appears on the display, and the Controller is ready for use.
~ If the incorrect code has been entered, the Controller remains locked.
Important
If you have selected a Custom lockout code, but you have
forgotten the code, a
Master Code is available. Refer to the
ScreenPRO-II Controller system’s most current
"
Whatsnew_ScreenPRO-II Controller.txt" document for
details. This document is bundled with every software
download. Note that the
Master Code changes with each
software version.