Instruction manual

ScreenPRO-II Controller • User’s Guide 235
6. Operations
Working with Layer Functions
tçêâáåÖ=ïáíÜ=i~óÉê=cìåÅíáçåë
The following topics are discussed in this section:
• Changing the Layer Mode
• Using Full Screen
• Using Clone
• Using Swap Z-Order
• Using Freeze
• Using Reset
• Using Join Mode
`Ü~åÖáåÖ=íÜÉ=i~óÉê=jçÇÉ
 Use the following steps to change the layer mode:
1. Ensure that the PIP or Key that you wish to change is selected in the Layer
Control Section
, and active for modification.
2. In the Layer Functions Section:
~ Press PIP to change a Key to a PIP, or ...
~ Press Key to change a PIP to a Key.
rëáåÖ=cìää=pÅêÉÉå
 Use the following steps to take the active PIP or Key to full screen:
1. Ensure that the PIP or Key is selected in the Layer Control Section, and active
for modification in Preview.
2. In the Layer Functions Section, press Full Screen. The source’s height will be
used as the parameter that define’s the full screen size. If borders are
ON, they
will be taken into account so that they are visible. Shadows will not be taken into
account for the full screen size.
rëáåÖ=`äçåÉ
The Clone mode is designed for widescreen configurations only. It enables you to make an
exact copy of a layer onto the opposite screen. All parameters of the PIP or Key are
cloned, including the shadow, key effects, border and size. Once cloned, you can select
between a “mirror” or an “offset” clone.
 Use the following steps to clone a layer:
1. Ensure that a PIP or Key is selected in the Layer Control Section, and active for
modification in Preview.
2. Ensure that the PIP or Key is positioned fully within the boundaries of an outside
destination’s screen. If the PIP or Key straddles the widescreen overlap region,
the mode cannot be enabled.
3. Press Clone to display the Clone Setup Menu.
Full
Screen
Clone