Instruction manual

206 ScreenPRO-II Controller • User’s Guide
5. System Setup
Input Setup
6. To configure a frame grab background:
a. Ensure that you have captured a still frame, either from a live DVI
background or from one of the two layers (
LAYER A or LAYER B). In
Chapter 6, refer to the “
Working with Still Frames” section on page 246
for instructions.
b. Scroll to the Type line and select FG_1, FG_2 or FG_3.
c. Press {SAVE}.
7. Repeat from step 3 for BG B.
8. Repeat from step 2 for the next destination’s background sources that you want to
configure.
9. When all background sources have been configured for all destinations, press
{HOME} to return to the Home Menu.
10. Press {SAVE} to save the new system configuration in memory.
fåéìí=pÉíìé
ScreenPRO-II Controller system setup: Step 16
S Prerequisites — Ensure that you are familiar with the Input Menu. In
Chapter 4, refer to the “
Input Menu” section on page 88.
In these procedures, you will set up the system’s inputs, and adjust phase and color
balance for wide screen configurations only. The following procedures are provided:
• Standard Input Setup
• Widescreen Phase and Color Balance Setup
pí~åÇ~êÇ=fåéìí=pÉíìé
 Use the following steps to set up inputs. This procedure applies to both single screen
and widescreen destinations.
1. On the Destination Bus, select the destination whose inputs you want to
configure.
2. On the ScreenPRO-II Controller console, select a layer (LAYER A or LAYER B).
3. Press {HOME} to display the Home Menu.
4. Press INPUT to display the Input Menu.
5. On the Source Selection Bus, select the first source that you want to set up.
6. Press {FORCE ACQUIRE} to perform the optimum image setup.
7. Perform additional setups on the Input Menu — if required:
a. If you need to manually set the resolution, scroll to the Format line and
select the desired format. Press
{APPLY FORMAT} to accept.
b. Scroll to the Sampling Mode line and set the sampling mode.
c. Scroll to the Contrast line and set the input’s contrast.
d. Scroll to the Brightness line and set the input’s brightness.
16