Instruction manual

ScreenPRO-II Controller • User’s Guide 205
5. System Setup
Background Setup
_~ÅâÖêçìåÇ=pÉíìé
ScreenPRO-II Controller system setup: Step 15
S Prerequisites — Ensure that you are familiar with the following menus:
~ Background Input Setup Menu. In Chapter 4, refer to the
“
Background Input Setup Menu” section on page 170.
~ BG Matte Menu. In Chapter 4, refer to the “BG Matte Menu” section on
page 174.
In this procedure, you will set up the Controller’s two “background” sources (for the
BG A
and
BG B buttons). Remember that each button can be configured as a live DVI input, as
a matte color, or as a frame grab.
 Use the following steps to set up your background sources:
1. Determine how you would like to configure your background and DSK sources.
As a recommendation, the following configuration is typically used:
~ The BG A input is configured as a live DVI source.
~ The BG/DSK Input B is used primarily as the DSK source, and
secondarily as a background frame grab source.
2. On the Destination Bus, select the destination whose background sources you
want to configure.
3. On the ScreenPRO-II Controller console, press BG A to display the Background
Input Setup Menu
.
4. To configure a matte background:
a. Scroll to the Type line and select Matte.
b. Press {MATTE} to display the BG Matte Menu.
c. Adjust the matte color as desired.
d. Press {BACK} to return to the Background Input Setup Menu.
e. Press {SAVE}.
5. To configure a live DVI background:
a. Ensure that your DVI source (PC) is properly connected to the
ScreenPRO-II chassis, and that the PC is turned on.
b. Ensure that EDID is properly set. If not, refer to the “Programming
EDID” section on page 190 for details.
c. Scroll to the Type line and select DVI.
d. Press {FORCE ACQUIRE}.
e. Press {SAVE}.
15
Note
In both single and widescreen modes, remember that BG B
and the
DSK are mutually exclusive. This occurs because
the
BG/DSK Input B is shared between the DSK and BG B
on all individual ScreenPRO-II units.